5
IMPORTANT:
Always use
ALKALINE
batteries only.
Do not use heavy duty batteries.
DO NOT MIX OLD AND NEW BATTERIES
Always re move the bat ter ies for pro longed stor age.
CHECK THE BATTERIES
if your detector exhibits any of the following
symp toms:
●
1
The unit does not turn on.
●
2
Low speaker volume.
●
3
Unit beeps continuously or erratically.
The LOW BATTERY indicator will come on and stay on if the batteries
are discharge. You may notice erratic beeping if using with LOW
BATTERY illuminated.
IMPORTANT:
Your Legacy 1000 met al detector re quires two 9-Volt
ALKALINE batteries.
Follow these steps to install the bat ter ies.
●
1
Carefully remove the battery com part ment door by pressing the re lease
clip on the right side of the door.
●
2
Snap one battery onto each of the terminals and place the bat ter ies in -
side the com -
part ment.
Insert booth of
the
batteries
with terminals
facing inward.
●
3
Replace
the
compartment
door by carefully
inserting op po -
site side of clip
first. Then press
down on clip
side until battery
door snaps into
place.
BATTERIES
Release
Clip
Both Batteries
terminals
facing in