14
IN THE FIELD TECHNIQUES
- Motion Modes
PINPOINTING
Accurate pinpointing takes practice
and is best accomplished by
“X-ing” the target area.
1.
Once a buried target is indicated
by a good tone response,
continue sweeping the coil over
the target in a narrowing
side-to-side pattern.
2.
Take visual note of the place on
the ground where the “beep”
sounds.
3.
Stop the coil directly over this
spot on the ground.
4.
Now move the coil straight
forward and straight back
towards you a couple of times.
5.
Again make visual note of the
spot on the ground at which
the “beep” sounds.
6.
If needed, “X” the target at
different angles to “zero in” on
the exact spot on the ground at
which the “beep” sounds.
7.
Use All Metal Mode (p16) for
more accurate pinpointing.
COIL MOVEMENT
When swinging the coil, be
careful to keep it level with the
ground about one inch from the
surface. Never swing the coil like
a pendulum.
CORRECT
WRONG
The
coil
should
be swung
in a
half-
circle
movement
as
illustrated
here.
Repeat this
motion
every step
you take to
guarantee that
the area is being
covered thoroughly.
7
TURN THE DETECTOR ON
Click the left knob to the on position.
The detector automatically enters the DISCRIMINATION Mode.
MOTION All METAL Mode
To operate in this mode:
• Turn the right knob, Disc/Notch, 100% counterclockwise, to the off
position.
• Press the DISC button.
• Reduce the Sensitivity Control to the 2:00 or 3:00 position.
• Sweep the coil over the surface of the ground.
The detector will emit one of three tones, depending on the type of metal
detected.
The top display will indicate the type of metal targeted.
The bottom display will indicate the depth, in inches, of coin-sized objects.
A worthwhile target is evidenced by a consistent tone, and a repeatable
target and depth indication as you sweep back and forth over the same spot
on the ground. Non-repeatable tones indicate the presence of trash objects
or highly oxidized metals.
You can increase the level of sensitivity, depending on the ground
conditions. If the detector emits false signals, simply reduce the Sensitivity
until the false signals cease. The detector will work well with the Sensitivity
in the 2:00 or 3:00 position, but higher Sensitivity settings will increase depth
detection.
DISCRIMINATION Mode
To operate in this mode:
• Press the DISC button.
• Reduce the Sensitivity Control
to the 2:00 or 3:00 position.
• Sweep the coil over the
surface of the ground.
• Turn the right knob,
Disc/Notch, to eliminate
unwanted items from
detection as illustrated to the
right:
BASIC OPERATION
