11
DOC: 100-032E
Questions?
800.753.9943
www.boundarytec.com
© 2015 BoundaryTEC, LLC.
Important!
Do not leave system unattended while in use.
Misuse or abnormal operating conditions can produce hot steam.
Steam can cause damage to water bags and risk of injury including burns. Temperatures
exceeding 212° F (100 C) are possible.
In the event that steam is produced
during operation
(indicated by a gurgling or hissing
sound similar to a coffee maker brewing) First, immediately remove coil from heat
without directly touching heated parts, then follow the troubleshooting
recommendations in this manual.
14.
REMOVE coil from the heat source using
a stick BEFORE water level reaches the
outlet port of supply bag.
Note:
There will remain a small amount
of water in the bag below the outlet
port. The water will not completely
empty from the bag.
15.
See - Shower Operation (pg. 13)
12
DOC: 100-032E
Questions?
800.753.9943
www.boundarytec.com
© 2015 BoundaryTEC, LLC.
Heating Recommendations
The
ShowerCoil
thermostat valve is very effective in controlling the heated water temperature across a
range of temperature and conditions. However, to ensure accurate water temperatures, follow the heating
recommendations below.
N/R
Not Recommended
Important!
Do not exceed maximum recommended heating intensity. Doing so can
produce water temperatures which exceed temperature setting.
Note
Normal heating times for a
full bag
of water will range from
10-18 minutes
.
If actual times are outside of this range, recheck the heat intensities above
and refer to the Troubleshooting section of this manual.
Tip
A fresh camp fire with flames passing over the coil will give the best heating
results.
Tip
Insulate the lower (heated) water bag from the ground by placing it on a
towel or foam pad when the outside temperature is cool (<65
°
F / <18 C).