Repair Instructions:
1)
hard surface. Use a soft damp rag or sponge to clean the area and
remove any excess dirt or other particles
2)
Do NOT continue repair when surface is moist! Make sure the
area is completely dry before continuing to proceed
3)
that the top and bottom are touching and smooth so there are no
wrinkles. Clean the damaged area with rubbing alcohol and do
the same for the patch
4)
Cut a smooth circular or oval patch with no sharp or irregular
edges from the patch material provided. The patch should be 1”
wider or more around the perimeter than the hole all around
5)
Lay the patch without glue on top of the hole with the shiny side
facing down. The patch should be covering the hole with the edge of
each section of the patch an equal distance from the edge of the hole
DO NOT GLUE
6)
moist
dry
patch
hole size
1 inch extra
material for
around the hole
place patch evenly
over the hole
hole under
patch
trace outside of the patch onto the surface of the comfy
peapod. Use a light colored crayon or colored pencil to
create the circle on the peeped. The tracing line should be 1
inch bigger than the hole on each side so the tracing should
be at least one inch away from the hole on all points
7) Apply a thin, even coat of glue from the patch kit to the shiny
side of the patch. Apply and spread the glue onto the peapod inside and just
outside of the traced line. Be sure that the edges of the whole patch would
later fit inside the glue area -
DO NOT APPLY THE PATCH
If you have any questions, please
visit:
bouncyband.com/pages/installation-guide
contact us. Phone:
(646) 926-2440
email:
