2.1.7.2
StepMetrix ID Connections
Refer to I D controller instructions 9ES-768 when
installing the ID connections.
1. Connect the StepMetrix ID anten na receive and
transmit cables to the ID controller (see Figure 14).
2. The receive c able has small black, large black and
yellow wires. Connect the large black wire to pin 1, the
small black wire to pin 2, and the large yellow wire to
pin 3.
3. Connect the transmit cable, which has two black wires
bonded together, to the trans mit terminals of J1 in th e
ID controller.
4. Verify that there is a jumper wire from pin 2 to 5 of J5,
and that SW1is set to 1 and SW2 set to C.
2.1.7.3
Communication
For detailed networking instructions, refer to
BouMatic’s Ethernet Co mmunications instructions,
9E-867.
2.1.7.4
StepMetrix Controller Setup
1. Turn on power to the power supplies.
2. Tune the tra nsmitter on the ID co ntroller (Refer to I D
controller Instructions 9ES-768).
2.2
Installing StepMetrix with ISO ID
2.2.1
Installing the StepMetrix Sensor Module
1. Place the StepMetrix sensor module on the floor.
Locate the conduits for the load c ell cables on th e
same side that the Ste pMetrix controller will be
mounted.
2. Once the sensor module is placed on the floor, walk on
the right and left sides of th e sensor module. If the
sensor module rocks, add shims underneath to stop the
rocking (see Figure 16). If the s ensor module is
fastened to the floor without shimming to eliminate the
rocking, it will cause a twist in the sensor module that
will hamper the performance of the s ystem and ma y
cause premature failure of the load cells.
3. Once the sensor module is neither rocking nor twisted,
fasten the sen sor module to the floor usin g concrete
anchors.
4. Walk on the sensor module after fastening the anchors
to make sure that the sensor module is not rocking.
15.
The StepMetrix™ with ISO ID system in place l864_18
StepMetrix™ Installation Instructions
9E-864C
15
