BouMatic Robotics MR-D1, Service Manual

Page: 278 / 446

Maintenance
Service: Continuation 3 and 7
Page 21-8 Version 1.7 23 June 2015
STEP ACTION
3. Remove the hoses at both sides from the connection pieces (1) (see
Figure 21-8 ).
4. Cut the silicon 2 way hose at one side 2 to 3 cm between the thick and
the thin hose.
5. Assemble the 2 way hose with the correct Oetiker clamps (see Figure
21-9 ) to the connecting piece at the teat cup position.
6. Assemble the other side at the other connection piece.
7. Check if the cups hang tight in the cup guides (1) (see Figure 21-10 ).
If the cups do not hang tight in the cup guides, the length of
the milk hose is not correct.
Figure 21-10 Cups in cup guide
8. Adjust the length of the milk hose, if the cup does not hang tight in the
cup guide.
Scheme 21-3 Replacing milk hoses
1