Model: BOT01-V3
Bottlelight Company Dr. Kitzenmaier
Gregor-Mendel-Str. 2
Tel.: +49 (0) 331 867 17 23
BOT01-V3_User Manual_2021 03 17_EN
14469 Potsdam/Germany
page 1
Bottle
Light
Insert the Bottlelight insert (1)
through the bottleneck into the
bottle down to the ground.
Press the ends of the spring element
(3) together and insert and push it
into the bottle until it falls over the
insert (1).
Attention !
Pull back the insert (1) at its cable
(4) so it slips into the spring
element (3) and stops below the
bottleneck, holding the bottle.
Please make sure that the bottle
sidewall sections (BS) being in
contact with the insert (1) have an
angle
α
in respect to a longitudinal
axis of the bottleneck exceeding 10°.
α
Hold the spring element (3) at
the thin extending wire and
push the insert (1) into the
bottle.
Connecting a bottle on the Bottlelight insert
Deconnecting the bottle from the Bottlelight insert
1
2
3
4
5
6
7
1
4
3
1
Fig. 4‘ shows an example
with the angle
α
being smaller than 10°, so causing the risk,
that the bottle will crack with an increasing
temperature and mechanical expansion of
the inset (1). The bottle can fall off then and
cause a damage.
4‘
4
1
BS
Pull the spring element (3)
somewhat upwards within the
bottleneck.
Then pull the insert (1)
together with the spring
element (3) out of the bottle
by the cable (4).
5
3
1
3
4
Attention
The hanging lamp insert heats up during
operation and must only be sufficiently
ventilated or in contact with a glass bottle
as a heat sink. The insert transfers the
resulting heat to the glass bottle.
The manufacturer does not give any
guarantee nor taking any liability for
damage or personal injury if an attached
bottle that has not been approved by the
manufacturer cracks and falls off due to
heat. For safety reasons, the pendant
lamp must not be placed above a person
area! Installation may only be carried out
by persons skilled in the art for installing
pendent lamps.
1
3
1
3
