Universal Remote Control (cont.)
(see Remote Control illustration on page 17)
case, there is usually output from all the
speakers, even though the source material
has not been encoded in the Dolby Surround
format.
NOTE:
Programs recorded in mono
will appear only in the center channel when
surround is activated.
Many listeners enjoy the three-dimensional
effect of regular stereo material played
through the Surround decoder.
previous
When using the remote to con-
trol your television, pressing this button
reverts to the previously viewed channel
(if your television has this function).
Programming the Universal Remote Control
This universal remote is pre-programmed for
hundreds of different devices.
Install the 4 “AAA” batteries in the remote.
Orient the batteries (+ or -) as shown
in the battery compartment.
For your TV, VCR, cable box, DSS, or DVD
player, look up the three-digit code for your
particular model in the included booklet.
Press the button for the unit you wish to
program—
TV, VCR
or cable box. The
LED on the remote will blink.
• The
VCR
button can also be used to
program DVD player codes, in place of
the VCR.
• The
cable
button can also be used to
program DSS codes, in place of the
cable box.
18
VOL-
VOL+
CH +
CH -
MUTE
VCR
TV
cable
powe
r
setup
power
Bosto
n
enter
previous
rew
paus
play
stop
fast fwd
record
VC
5-ch / 2-ch
test tone
L front
R front
center
L R
subwoofer
Audio
DVD/night
DSS/night
pause
R
rear
rear
•
8
•
1
•
1
•
2
•
3
•
4
DT7000 Manual 11/99 rev2 11/24/99 12:19 PM Page 18
