13-ENG
ASSEMBLY
Loading The Tool
When loading tool: 1) Never place a hand
POSITION 2
POSITION 1
or any part of body in fastener discharge area of tool;
2) Never point tool at anyone; 3) Do not pull the trigger
or depress the safety lever as accidental actuation may
occur, possibly causing injury.
1. Disconnect the battery.
2. Pull back the pusher until it is tucked under the rear of the
magazine in
POSITION 1
.
3. Check staple leg length.
Adjustment is provided in the tool for different staple leg
lengths.
A) To adjust the tool for leg length install the correct
clinchers and adjust the length dial to the setting
corresponding to the fastener being driven.
4. Load the staple stick from the rear of the tool
(POSITION 2)
.
5. Slide the pusher from
POSITION 1
until engaged behind the staples.
Battery Installation
INSTALLING AND REMOVING THE BATTERY PACK
Make sure your battery pack is fully charged. To install the battery pack
(6) into the tool handle, align the battery with the rails inside the tool’s handle and slide it
firmly into the handle until you hear the lock snap into place. To remove the battery pack
from the tool, press the release button (11) and firmly pull the battery pack out of the
tool handle. Insert it into the charger as described in the charger section of this manual.
11
6
11
6
