31
Resetting the Pedal Sensitivity (PEDAL CALIBRATION Mode)
The PW-10’s pedal sensitivity has been adjusted at the factory, so this procedure is
not usually necessary. However, if the wah effect is not being applied when you
press the pedal, if the effect sounds strange, or if the pedal exhibits other such prob-
lems, use the following procedure to make the settings.
1.
Turn off the power to the guitar amp.
2.
Switch off the PW-10’s power.
• When running on battery power:
Disconnect the connection plug from the
INPUT jack.
• When running on power from an AC
adaptor:
Disconnect the plug from the AC Adaptor
jack.
3.
Turn the TYPE knob to CBY-WAH.
4.
While holding down the MANUAL/
MEMORY button, switch on the PW-
10’s power.
• When running on battery power:
Insert the connection plug into the INPUT
jack.
• When running on power from an AC
adaptor:
Insert the AC adaptor plug into the AC
Adaptor jack.
The ON/OFF indicator flashes four times,
and the PW-10 switches to PEDAL CALI-
BRATION mode.
5.
Turn on the power to the guitar amp.
Summary of Contents for V-Wah PW-10
Page 42: ...42 Setting Memo ...
Page 44: ...G6017356 ...
