Boss MSC01141, Installation Instructions

Page: 3 / 4

For HTX and UTV V-Blade
Plows
Model MSC09235
1. Assemble the casters as shown in Figure 7 .
g038533
Figure 7
1. Nut (5/16 inch) 4. Small caster
2. Washers 5. Bolt (5/16 inch)
3. Small caster base
2. Park the machine on a level surface, raise the
plow fully, and place 2 safety jack stands under
the plow cutting edge.
3. Shut off the engine, wait for all moving parts to
stop, engage the parking brake, and remove
the key.
4. Slide the small caster shoes into the shoe
holders on the plow and secure them with a
quick pin (
Figure 8 ).
Note:
Adjust the number of washers above
and below the shoe holder or center bushing as
needed.
g038534
Figure 8
1. Quick pin 3. Washers
2. Small caster shoe
5. Remove the safety jack stands and lower the
plow in the “V” position.
6. Follow the plowing procedures in your Owner’s
Manual .
For DXT V-Blade Plows
Model MSC01141
1. Assemble the casters as shown in Figure 9 .
g038535
Figure 9
1. Washers 4. Center caster
2. Carriage bolt 5. Nut (3/8 inch)
3. Plastic knob 6. Caster
3