Boss Snowplow RT3 DXT, Installation Instructions Manual

Page: 14 / 36

g032927
Figure 21
1. Plow controller 4. Black wires
2. Controller connector 5. Headlight toggle switch
3. Black/red wire
12. Connect the 2 black wires to the headlight toggle
switch (
Figure 21 ).
13. Determine where you will mount the headlight
toggle switch and clean the area thoroughly.
Note:
Allow the area to dry completely after
cleaning.
14. Remove the adhesive backing and press the
toggle switch to the clean area of the dashboard
for 30 seconds.
15. Plug the controller connector into the plow
controller.
16. Mount the plow controller; refer to Mounting the
Plow Controller (page 17) .
17. Connect the black/red wire to a keyed 12 V +
ignition source.
Note:
Connecting the wire to a source that is
not keyed can cause the battery to drain.
18. Connect the white/black wire from the wire
harness to the small post on the pump solenoid
(
Figure 22 ).
g032928
Figure 22
1. White/black wire 4. Pump solenoid
2. Battery cable 5. Brown wire
3. Red power/ground cable
19. Connect the brown wire from the wire harness
to the other small post on the pump solenoid
(
Figure 22 ).
Note:
The wires may go on either small post,
but should not share a post.
20. Mount the pump solenoid inside the engine
compartment of the vehicle, ensuring that it
stays in an upright position and does not contact
the body, hood, or other conductive material on
the vehicle.
21. Connect the red power/ground cable to the large
post on the pump solenoid (
Figure 22 ).
22. Connect the battery cable to the other large post
on the pump solenoid (
Figure 22 ).
Note:
The wires may go on either large post,
but should not share a post.
23. Connect the black power/ground cable to the
negative (-) battery terminal (
Figure 23 ).
14