www.bia.lighting | [email protected]
page 4 / 2
P R O D U C T M A N U A L
COPYRIGHT BIA
©
2020
V
03.20
DRIVER
CONTROLLER
+
-
+
RGBW
RGBW
RGBW
-
+
-
INSTALLATION INSTRUCTIONS
A
DIRECT INSTALLATION INTO DECKING
1.
Before commencing installation, ensure the main power is
switched off.
2.
Measure and cut hole to 225mm.
3.
Lay conduit and prepare wiring.
4.
Connect and waterproof all wiring.
5.
Hold the clips and gently push luminaire into place. The face of
the luminaire must be
fl
ushed against the installed surface.
6.
Secure with screws.
B INSTALLING INTO A CANISTER
1.
Before commencing installation, ensure the main power is
switched off.
2.
Canisters are to be installed prior to concrete work. Please plan
accordingly and allow for adequate drainage.
3.
Secure canisters into intended position. Lay conduit and prepare
wiring.
4.
Connect and waterproof all wiring.
5.
After the concrete has cured, install luminaire by holding the clips
and gently push luminaire into place. The face of the luminaire
must be
fl
ushed against the installed surface.
WARNING! all wiring and connection points must be waterproofed to
the required IP rating.
DIAMENSION DIAGRAM
5
6
4
4
3
2
225mm
24V single
conduit
24V RGB
canister
55mm
100mm
248mm
220mm
204mm
204mm
Ø6.5mm