MRWT69
550 WATT 4-Way Fully Marinized
Marine Waketower Speaker Pod
Mounting
1.
The speaker is pre-attached with a mounting clamp via two supplied bolts.
Find two bolts attached to the upper clamp. Then unfasten the bolts to remove the upper clamp from
the speaker.
Important notes on mounting
●
2.
Place a supplied rubber pad on the inner surface of the lower clamp which is fixed to the speaker.
The rubber pad is used to prevent abrasion and secure clamping.
3.
Place the other supplied rubber pad on the surface of the mounting bar.
Then tighten the upper clamp to the lower clamp with the two bolts. Make sure both bolts are evenly
tightened.
It is strongly recommended that you work with an assistant to install the speaker.
●
The supplied rubber mounting pads must be used to prevent abrasion and secure clamping.
●
To ensure security of the mounted speaker, check the mounting conditions (e.g. clamp fastening) of
the speaker regularly or before each vehicle ride.
●
The supplied clamps accept the tubing ranged Ø 2” – 3” (51 - 76 mm) to attain strong and safe hold. If
a gap around the clamped tube occurs for clamping looseness, use universally available rubber
inserts to fill the gap to prevent the movement of the mounted speaker.
●
Use only the supplied accessory for mounting. Using other mounting methods may void the warranty.
2.
1
2
3
Upper clamp
Rubber pad
Lower clamp
Mounting bar
