Simple Troubleshooting Guide
Image Blurring
Please check if there is water stain or dust on
the camera.
.
Image Shaking
Please adjust and fix-up
.
No Image.
Please check if the power cable is well connected.
.
Note:
If any of the problems persist after check list had been made, consult your nearest
service dealer. Never attempt to disassemble your unit by yourself.
The following checklist might help to solve the problems which you meet when using
the unit. Please double check and make sure if the connection and the procedure of
the operation is done properly before using the checklist
.
below
Problem
Cause/Solution
Image Slanting
Please adjust the bracket of camera
.
Please make sure good connection between the
video in and the monitor.
.
Please check if reverse gear is in place.
.
Please make sure correct setup of monitor.
.
Please make sure cleaness of the camera lens.
.
Red and black back lights 12V Line
DC 12V
DC 12V
AV
Power / video
Camera
Complete all of the required connections in the way that make all the lines
hided in the car.
Installation
1. Wire connection
2. Installation
The camera can be installed in the following way
:
License plate screw-hole mount (see diagram 1)
License plate camera: Mount in the screw hole on the license plate,
then affix with a nut.
Attention: The camera switch is controlled by the reverse gear shift.
(diagram 1)
