BPS80 Amplified Subwoofer User’s Manual - Page 7
Attach the included remote level
After you have installed your system,
Turn the head unit on (and the
Slowly turn up the subwoofer input
gain control until you hear a small
amount of distortion. Then reduce the
level until the distortion is completely
The bass boost feature will increase
the sound level in the bass
frequencies.
gone. Leave the control at this setting.
subwoofer will turn on via the remote
connection). Turn the head unit
volume to about 2/3 full level.
turn this control to minimum
control to the port to control the volume
level of the subwoofer independently.
REMOTE LEVEL CONTROL PORT
This control permits you define the
frequency range you want the
subwoofer amplifier to receive. The
subwoofer will reproduce all sound
BELOW the frequency you set.
If the rest of your system is weak on
the mids, you may wish to set this
control relatively high. If the midrange
is well covered by the rest of your
system, you will probably want the
subwoofer to only receive lower
frequency signal.
Use this switch to help compensate
for time alignment problems in the
from having the subwoofer at a
different distance from the listener
than the other speakers in the system.
This LED is green when power
is on and no problems are
present.
system. Such problems usually result
LOW PASS FILTER
PHASE SHIFT
POWER STATUS LED
INPUT GAIN CONTROL
BASS BOOST
Front panel controls and features
PROTECT STATUS LED
This LED will be red if one of the
protection circuits comes on.
Summary of Contents for BPS80
Page 13: ......
