FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of this device.
1- ATV80 All Terrain Speaker System
1- Quick Connect Power Extension Adaptor
2- Nylon Mounting Straps and Nylon Zip Ties
1- User Manual Quick Start Guide / Poster
1- Warranty Card
USER MANUAL
QUICK START GUIDE
Thank you for purchasing this
ATV80 All Terrain Sound System
Please read through these instructions carefully so you will know
how to operate your model properly.
After you have finished reading the instructions, keep this document
in a safe place for future reference.
BEFORE YOU START
INFORMATION TO THE USER
CAUTION!!
ADJUSTMENT OR ALTERATIONS OF THIS PRODUCT MAY RESULT
IN HAZARDOUS OPERATION.
IMPORTANT SAFETY PRECAUTIONS
● Do not operate mobile equipment while driving a motorized vehicle – safe driving
and safety consideration of others should always be your highest priority.
● In the event you should notice smoke, strange noises or odor from this product, or
any other abnormal signs, immediately turn off the power and consult your dealer or
the nearest authorized BOSS AUDIO Service Center. Using this product in this
condition may result in permanent damage to the system.
● Set your volume control at a low setting, then slowly increase the sound until you
can hear it comfortably without distortion, or ear discomfort.
● BE SURE TO OBSERVE THE FOLLOWING GUIDELINES:
- Do not turn up the volume so high that you can’t hear what’s around you.
- Use caution or temporarily discontinue use in potentially hazardous situations.
INSTALLATION PRECAUTIONS
WARNING - Always consult a professional installer
● Do not attempt to install or service this product by yourself. Installation or servic-
ing of this product by persons without professional training and experience in
electronic equipment and motorized vehicle accessories may be dangerous and could
expose you to the risk of electric shock, injury or other hazards
● Refer any repairs to a qualified BOSS AUDIO SYSTEMS Service Center
● The ATV80 can be powered from a vehicles cigarette lighter / auxiliary power port,
or hard wired directly to the battery through an optional relay / accessory switch
● When wiring directly to the vehicles battery, be sure to disconnect the batteries
negative terminal wire before starting any wiring procedures, it is suggested that an
optional fuse and fuse holder (not included) with minimum rating of 20 Amps be in
line with the positive battery terminal
● The ground cable length should not exceed 18-inches (See wiring diagram)
● The ATV80 has a weather resistant design, it should not be submerged in or
under water under any circumstances
● Use only the installation parts provided with the ATV80
BEFORE INSTALLING THIS PRODUCT
CAUTION!!
USING OTHER MOUNTING METHODS MAY VOID THIS WARRANTY
POWER ON AND AUX-IN OPERATION
1) Power on the ATV80 by plugging into a 12VDC power adaptor
2) Route the integrated 3.5mm AUX-IN cable located on front side of the ATV80
thorough the supplied soft carry pouch
3) Connect your device headphone jack to the 3.5mm AUX-IN cable
4) Thread the strap through the pouch, secure the pouches top cover
5) Wrap and firmly fasten the pouch strap around the center of the ATV80
6) Secure any loose wiring before vehicle usage
VOLUME CONTROL
7) To raise or lower the volume use your media player master volume controller
Make sure your device headphone volume is set at comfortable
level before stowing in to the carry pouch
The ATV80 can play audio from any device that has a 3.5mm headphone audio jack.
INSERT
WIRE
INSERT
QUICK RELEASE
POWER ADAPTOR
(INCLUDED)
POWER ADAPTOR
MEDIA
PLAYER
SOFT
POUCH
YOUR
MEDIA
DEVICE
INSERT
DEVICE
SECURE
POUCH
STRAP
POUCH
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
GETTING TO KNOW YOUR ATV80
When replacing the fuse, be sure to only use a fuse of the rating specified on this
product. To avoid short-circuiting, cover any disconnected leads with insulating tape.
It is especially important to insulate any unused wires, which if left uncovered may
cause a short circuit. When connecting other devices to this product, refer to the
manual for the product to be connected. The black cable is ground, make sure to
connect the ground wire first. Ensure that the ground wire is properly connected to
metal parts of the vehicles body frame or direct to the battery if your vehicle does
not have a grounded chassis frame The ground wire of this units power amp and a
second powered system must be connected to the frame separately with different
screws. If the screw for the ground wire loosens or falls out, it could result in fire or
malfunction.
To avoid potential shorts in the electrical system, be
sure to disconnect the (–) battery cable before
installation. Use this unit with a 12-Volt battery and
negative grounding only.
Failure to do so may result in a fire or malfunction.
SPEAKER MOUNTING SUGGESTIONS
CAUTION!!
Mounting strap buckles should be double checked to ensure they are tight and
secure before each use of the vehicle.
ALL-TERRAIN SOUND SYSTEM
ATV80
USER MANUAL
FEATURING 8” MARINE GRADE SPEAKERS
AND SWIVEL 1” SOFT DOME TWEETERS
with BUILT-IN HIGH POWERED INTERNAL AMPLIFIER
QUICK START GUIDE
ATV80
USER MANUAL
AUX-IN | ALL-TERRAIN SOUND SYSTEM
PRINTED IN CHINA
VER:1.02 EN
iPod / iPhone are trademarks of Apple Inc. registered in the U.S. and other countries.
BOSS Audio Systems is not affiliated with Apple Inc.
715
BOSS Audio Systems
3451 Lunar Court • Oxnard, CA 93030
www.bossaudio.com | 1.805.751.4853
Tech Support: www.bossaudio.com/support
AUX-IN
• 3.5mm
• Cable length: 5ft / 1.5m
SPEAKERS
• Dimensions: 8” /219.8mm
• Impedance: 2Ω + 2Ω
• Cone Type: PP RUBBER SURROUND
• Tweeter Size: 1” PEI SOFT DOME
AMPLIFIER
• Maximum Output Power: 700
Watts
• Input impedance: 10kΩ
• Frequency Response: 45Hz-25kHz
SPECIFICATIONS
WIRE DIAGRAM
15A
Fuse and fuse holder
(not included)
Chassis
ground
point
BATTERY
Fuse is located inside the power adaptor
Turn counter clockwise to open
Replace with 15A AGC Fuse type only
Normally open switch
(not included)
OPTIONAL DIRECT BATTERY WIRING CIRCUIT
RED
BLACK
Chassis
ground
point
QUICK RELEASE
POWER ADAPTOR
(INCLUDED)
Ground wire
Metal frame
Recommended 12 ~ 14ga Wire
(not included)
POWER ADAPTOR
3.5mm AUX INPUT
Normally open switch
(not included)
GENERAL
• Operational Power: 12VDC (10-16V allowable)
• MAX Current Draw: 13.7A
• Replacement Fuse: 15A AGC TYPE
• Color: Black
• Weight: 20.8lbs / 9.43Kg
• Dimensions cm WxHxD: 80.3 x 22.9 x 33.4
• Dimensions Inches WxHxD: 31.63 x 9.00 x 13.15
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or by any means, including
photocopying, recording, or other electronic or mechanical methods, without the prior written permission of AVA Enterprises Inc.
Copyright © 2015 BOSS AUDIO SYSTEMS Inc.
THIS PACKAGE CONTAINS
OPERATION
NOTE: The carry soft pouch is designed to keep your device safe from debris, make
sure to close the pouch cover securely before each vehicle use.
1) Route 2 mounting straps securely around your vehicles metal rack bar system
2) To tighten, pull excess slack through strap buckles
2
1
3
2
4
6
1
5
