6
5.
A.
Identify the positive output lead from the trans-former
according to the system’s power require-ments (see
table below). That lead’s power rating indicates where
you will “tap” the transformer.
Red ................................................ 150W
Blue ........................................ 75W
Green ..................................... 38W
White ...................................... 19W
B.
Pull the cutaway tip of the insulation off that lead.
C.
Clip the three unused leads off at the transformer
windings (Figure 4a).
D.
Connect the positive lead, which is hanging loose, to
the red wire inside the array (Figure 4b).
E.
Connect the black wire on the CVT-5 transformer to the
black wire inside the array.
Note:
Soldering and insulating with electrical tape is the method
Bose
®
recommends for connecting wires. Using a small crimp-type
butt splicer is also acceptable.
We do not recommend wire nuts, terminal blocks, or similar
solderless devices, which could rattle inside the 502
®
A array or
touch the rear of one of the driver cones during use of the system.
