__________________________________________________________________________________________
BoscoLighting
ABN: 88 152 438 974
(
02
)
9188 3470
BoscoLighting Extrusion
Installation Instruction
Introduction
Thank you for choosing BoscoLighting products.
This document aims to guide a qualified installer or
electrician in installing of this product to ensure correct
function and safety. Note by Law, certain electrical works
must be completed by a licensed electrician. Each State
maintains their own licensing system, for more
information see
www.erac.gov.au/index.php?Itemid=516
Warranty
Your BoscoLighting light fitting is covered by a 3 year
warranty. Please retain proof of purchase or register your
purchases
by
sending
an
to
by attaching a copy of
your purchase invoice, details of the end user (name,
company, phone and address) and electricians company
and electrical license number.
Warranty will be void if there is any damage due to
improper installation, modification to the fitting except
from the standard issued parts and features or used for
purposes other than the intended purpose and safety
precautions and warnings had been disregarded, site
issues like voltage surges, vandalism or rodent damage.
Safety Instructions
●
First and foremost, do not install or operate the fitting
if it appears to be damaged in any way. Please inform
your
local
supplier
or
send
an
to
as stated on the
warranty section of this document.
●
Electrical connections and wirings must be
carried
out
by
a
licensed
electrician
in
conformance with the electrical standards.
●
BoscoLighting extrusions can be installed surface
mounted, suspended or recessed. Please make sure
that you have sufficient structural support for any of
these installations. Standard supply lengths for
extrusions are 1 or 2 meters, customised lengths may
also be available as per order.
●
It is standard to supply extrusion with strips and
drivers separately to be assembled together onsite.
We also offer a pre-assembly service where the strips
are installed into the extrusions for an extra fee.
●
Turn off the fuse/circuit breaker that controls the
power to the area or fixtures that you are working on.
Turn off as well the light switches on your wall and do
not forget to test the electrical wires for voltage
presence
before
you
start
working
to avoid
unexpected electrical shock.
●
Please use our IP65 LED strip when the installation is in
a wet or damp location.
●
Use proper electrical protective gears and electrical
tools during the installation.
Installation Instructions
●
STEP 1: When making a customized cut-length, please
put a painter or masking tape first on the area where
you are going to do the cut then mark the desired
measured cut-length on top of the tape. Please use an
L-Square ruler to ensure that you have a perfect 90
degrees perpendicular guide mark. The tape on the
1
