Bosch YS1780RA, Owner'S Manual

Page: 19 / 36

19
Operating Instructions
3
Set temperature.
(
Always check
)
temperature setting
before use.
Hot
Cold
Check the indicator lights.
Bath Fill temperature
5
Turn on hot
water.
4
Adjust bath fill
volume setting.
To set the Bath Fill Volume:
Press the Bath Fill button (the setting
will flash on the display) and adjust
with the setting buttons.
Increase
Decrease
Choose the bath fill volume setting from the
following options: 40 - 80 (In 20 litre intervals),
120 - 200 (In 40 litre intervals), or 250 - 650
(In 50 litre intervals).
* Initial factory setting: 160 litre.
Bath fill volume setting will be flashing
(Eg. 200 litre.)
* The level can only be adjusted while the
indicator is flashing.
* After ten seconds, the remote
will again display the temperature.
* For Bathroom controller.
To alter the bath fill volume press the
priority button after the bath fill button.
* Initial factory setting: 40°C
Warmer
37 38 39 40 41 42 43 44 45 46 47 48
Hot Warm
(
°
C:
)
Water Temperature
On On
In order to run a warm bath, push the bath fill
button and open the hot water tap of the bath.
When the bath has reached the volume set
on the controller, an alarm sounds and the hot
water supply will stop automatically.
Once the bath fill is complete, please close
the tap as the water heater cannot operate
until this is done.
The temperatures settings below are only examples. The
temperature setting necessary will depend on the usage,
the length of piping or seasons.
Filling Up the Bath