en
Installation and connection
12
1.
Remove any packaging and pro-
tective covers completely from the
appliance.
→
2.
Check the appliance for visible
damage.
3.
Open the appliance door.
→
4.
Remove any accessories from the
drum.
5.
Close the appliance door.
4.2 Contents of package
After unpacking all parts, check for
any damage in transit and complete-
ness of the delivery.
ATTENTION!
If the appliance is operated with in-
complete or defective accessories,
the appliance may not be able to op-
erate properly, or this may result in
material damage or damage to the
appliance.
▶
Do not operate the appliance with
incomplete or defective accessor-
ies.
▶
Replace the accessories in ques-
tion before operating the appli-
ance.
→
Note:
The appliance has been tested
at the factory to check it is in working
order. As a result, water stains may
remain in the appliance. These marks
will disappear after the first wash
cycle.
The delivery consists of the following:
¡
Washer dryer
¡
Accompanying documents
¡
Transit bolts
→
¡
Cover caps
¡
Water inlet hose
→
¡
Screws and cover plate
4.3 Requirements for the in-
stallation location
WARNING
Risk of electric shock!
The appliance contains live parts.
Touching live parts is dangerous.
▶
Do not operate the appliance
without a cover cap.
WARNING
Risk of injury!
When using the appliance on a base,
the appliance may tip over.
▶
Always secure the feet of the appli-
ance to a base using the manufac-
turer's fixing brackets →
before using the appliance for the
first time.
ATTENTION!
If residual water in the appliance
freezes, this may cause damage to
the appliance.
▶
Do not install or operate this appli-
ance anywhere that is liable to ex-
perience frost or outdoors.
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
▶
Tilt the appliance carefully.
▶
Transport the appliance in an up-
right position.