Bosch WZ16, Installation Manual

Page: 6 / 28

6 en | Safety WZ16 Integrated IR Bullet Camera
| 1.0 | 2011.02 Installation Manual Bosch Security Systems, Inc.
1.3 Important Notices
All-pole power switch - Incorporate an all-pole power switch,
with a contact separation of at least 3 mm in each pole, into the
electrical installation of the building. If it is needed to open the
housing for servicing and/or other activities, use this all-pole
switch as the main disconnect device for switching off the
voltage to the unit.
Camera grounding - For mounting the camera in potentially
damp environments, ensure to ground the system using the
ground connection of the power supply connector (see section:
Connecting external power supply).
Camera lens -
An assembled camera lens in the outdoor
housing must comply and be tested in accordance with UL/
IEC60065 . Any output or signal lines from the camera must be
SELV or Limited Power Source. For safety reasons the
environmental specification of the camera lens assembly must
be within the environmental specification of -10 °C to 50 °C
(14 °F to 122 °F).
Camera signal - Protect the cable with a primary protector if
the camera signal is beyond 140 feet, in accordance with
NEC800 (CEC Section 60) .
Accessories - Do not place this unit on an unstable stand,
tripod, bracket, or mount. The unit may fall, causing serious
injury and/or serious damage to the unit. Use only with the
cart, stand, tripod, bracket, or table specified by the
manufacturer. When a cart is used, use caution and care when
moving the cart/apparatus combination to avoid injury from
tip-over. Quick stops, excessive force, or uneven surfaces may
cause the cart/unit combination to overturn. Mount the unit
per the manufacturer's instructions.