Operating the appliance
en
19
Notes
■
If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ
is lit
~
Reloading is not
possible. To continue the
programme, select the
Start/Reload
A
button.
■
Do not open the door until the door
lock symbol
Õ
goes out.
■
Do not leave door open for
a prolonged period – water could
run out of the laundry.
■
The reloading function cannot be
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Select
Start/Reload
A
.
2.
Select another programme. If
required, adjust the default settings
and/or select additional functions.
3.
Select
Start/Reload
A
. The new
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
1.
Select
Start/Reload
A
.
2.
To cool down laundry: Select
Rinse
O
.
3.
Select
Start/Reload
A
.
For programmes at low temperature:
1.
Select
Start/Reload
A
.
2.
Select or
Spin
/
Drain
0
/
[
.
3.
Select
Start/Reload
A
.
For drying programmes:
1.
Select
Intensive Dry
5
or
Gentle
Dry
‰
.
2.
Touch button
Š
Dry
and set drying
time to 15 minutes.
3.
Select
Start/Reload
A
.
End of the programme
End
or
– – – –
(
Rinse stop
= without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If
– – – –
(
Rinse stop
= without final
drain/spin cycle) was selected, press
Start/Reload
A
button to start the final
drain/spin cycle.
Notes
■
The programme continues by
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
■
If only the water is to be pumped out,
approx. 1 minute after the
programme starts, touch the
Start/
Reload
A
button before the spin
cycle starts. The programme is
interrupted and the door lock is
released. The laundry can be
removed.
■
If
Hot
flashes in the display before
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
