Noises
en
27
5.
The volume for the
audible signal at
the end of the programme
is shown
on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
6.
Press the "Ready in" time button to
change the volume.
7.
Turn the programme selector
clockwise to position 4.
8.
The volume for the
audible button
signal
is shown on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
9.
Press the "Ready in" time button to
change the volume.
Note:
You can select other positions
with the programme selector; however,
you will be unable to change these
settings.
Exiting setting mode
Turn the programme selector to the
"Off" position once you have set the
required spin speed and the volume.
The settings have now been saved.
>
Noises
Noises
Note:
During drying, particularly in the
initial phase, operation of the appliance
results in noise from the compressor
and pump. This is perfectly normal and
does not impair proper functioning of
the appliance.
From time to time, the compressor in
the dryer generates a humming noise.
However, the volume may vary
depending on the programme and
progress of the drying process.
Every now and then, the compressor is
ventilated. This creates a whirring noise.
The condensation is pumped into
the condensate container by a pump.
This generates pumping noises.
