en
operation
28
12.4 Starting the programme
Requirement:
A programme is set.
"Setting a programme", Page 27
▶
Press
Start/Nachlegen
.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows: "End" .
12.5 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡
The programme is set.
→
"Setting a programme", Page 27
¡
The "Ready in" time is set and ac-
tivated.
→
1.
Press
Start/Nachlegen
.
The activated "Ready in" time is
paused.
2.
Press
Fertig in
repeatedly until
the display indicates the desired
"Ready in" time.
3.
Press
Start/Nachlegen
.
The changed "Ready in" time is ac-
tivated.
12.6 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Requirement:
A programme has
started.
→
1.
Press
Start/Nachlegen
.
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
Start/Nachlegen
.
12.7 Cancelling the pro-
gramme
1.
Press
Start/Nachlegen
.
2.
Open the appliance door.
3.
Remove the laundry.
→
12.8 Unloading the laundry
1.
Open the door.
2.
Remove the laundry from the
drum.
12.9 Switching off the appli-
ance
▶
Turn the programme selector to
Aus
.
12.10 Fluff filter
During drying, fluff from the laundry is
collected in the fluff filter. The fluff fil-
ter protects the appliance from fluff.
Cleaning the fluff filter
If the drying programme has finished
or the display shows a notification
while the appliance is in operation,
clean the fluff filter.
Note:
If you do not clean the appli-
ance as described, the appliance's
functionality may be impaired.
Requirements
¡
The display shows the following
after drying: "End"
¡
or during operation: .
1.
Open the door.
