en
Setting the signal and current
26
2.
Pour out the condensation water.
Caution!
Dirty condensation water may be
harmful to your health and cause
material damage.
Condensation water is not suitable
for drinking and may be
contaminated with fluff. Do not drink
the condensation water or reuse it.
3.
Push in the condensate container
until you feel it lock back into place
in the dryer.
M
Setting the signal and
current
Setting the signal and current
You can change the following settings:
■
The spin speed that is used for
spinning your laundry before it is
dried,
■
The volume of the audible signal at
the end of the programme,
■
The volume of the audible button
signals,
■
The current rating for your dryer's
fuse (10 A or 16 A).
Note:
The values for the energy
label are determined using a circuit
breaker/fuse rating of 16 A. If the
circuit breaker/fuse rating is
changed to 10 A, the drying time
and energy consumption will be
higher. You can find details on this in
the consumption values table.
You must activate the setting mode in
order to change these settings.
Activating setting mode
1.
Switch the dryer on.
2.
Select the "Cottons" programme in
position 1 and wait for five seconds.
Setting mode is now activated. The
symbols go out in the display panel and
the programme duration is displayed.
1.
Press and hold the Start button and,
at the same time, turn the
programme selector clockwise to
position 2.
2.
The
spin speed
is shown in the
display.
