5
6
no p
a
a
ˎ
ø
'
ˎ
!
bü
a
no p
a
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
Care and cleaning
Dryer cabinet, control panel, air cooler, moisture sensors
– Wipe off with a soft, damp cloth.
– Do not use abrasive cleaners or solvents.
– Remove detergent and cleaning agent residue immediately.
Clean the air cooler 5 to 6 times a year
or if
no
/
p
(Container/Cleaning)
flashes after cleaning the fluff filter.
Air cooler
In order to clean it, the air cooler must be removed.
– Allow the dryer to cool.
– Residual water may leak out, so place an absorbent towel underneath
the maintenance door.
1.
Unlock the maintenance door (1).
2.
Fully open the maintenance door (2).
3.
Turn both locking levers outwards (1).
4.
Pull out the front insert (2).
5.
Remove the air cooler.
Take care not to damage the air cooler.
When cleaning, use warm water only. Do not use hard or sharp-edged objects.
6.
Clean the air cooler thoroughly and allow the water to drain off.
Clean the seals.
7.
First insert the air cooler (handle at the bottom) and then the front insert.
8.
Turn back both locking levers.
9.
Lock the maintenance door.
Moisture sensors
The dryer is fitted with stainless steel moisture sensors. The sensors measure the level of
moisture in the laundry. After a long period of operation, a fine layer of limescale may form
on the sensors.
1.
Open the door.
2.
Clean the moisture sensors using a slightly damp sponge with a rough
surface.
Do not use steel wool or abrasive materials.
1
2
3
Information on laundry ...
Labelling of fabrics
Follow the manufacturer's care information.
(
Drying at normal temperature.
'c
Low-temperature drying
a
in addition, select
(Low heat)
.
)c
Do not machine dry.
Be sure to follow the safety instructions
a
see page 11
!
For example, do not use the dryer for the following fabrics:
– Airtight fabrics (e.g. rubber-coated fabrics).
– Delicate materials (silk, curtains made from synthetic material)
a
they may crease.
– Laundry contaminated with oil.
Before drying for the first time
– Do not put any laundry in the dryer. Set the programme selector to a timed programme
(
a
see page 7
) and select
(Start
/Pause
)
. When the programme has finished, set the
programme selector to
O (Off)
.
Drying tips
– To ensure a consistent result, sort the laundry by fabric type and drying programme.
– Always dry very small fabrics (e.g. baby socks) together with large items of laundry
(e.g. hand towels).
– Fasten zips, hooks and eyelets, button covers and tie together cloth belts, strips, etc.
– Do not overdry easy-care laundry
a
risk of creasing.
Allow laundry to finish drying in the air.
– Do not iron laundry immediately after drying, fold items up and leave for a while
a
the
remaining moisture will then be distributed evenly.
– Knitted fabrics (e.g. T shirts, knitwear) often shrink when tumble dried for the first time
a
do not use the
Very Dry
programme.
– Starched laundry is not always suitable for dryers
a
starch leaves behind a coating that
adversely affects the drying operation.
– Use the correct dosage of fabric softener as per the manufacturer's instructions when
washing the laundry to be dried subsequently.
– Using a timed programme with a small laundry load
a
optimisation of the drying result.
Environmental protection/energy-saving tips
– Before drying, spin the laundry thoroughly in the washing machine
a
the higher the spin
speed, the shorter the drying time will be (consumes less energy), also spin easy-care
laundry.
– Use the maximum recommended fill level but do not overload laundry
a
overview of programmes, see page 7
.
– Make sure the room is well ventilated during drying.
– Clean the fluff filter after every drying cycle
a
see page 4.
– Do not block or seal the air inlet.
Only when the appliance is
switched off.
ʋ
ʋ
a
a