Faults and what to do about them
en
33
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
ç
on the display panel.
■
Clean the fluff filter. Select the Start button to reset the displayed indication
and then select the Start button again to restart the appliance if necessary.
■
Check if exhaust air duct is blocked or bent. Clean the exhaust air duct
. If necessary, clean the insect screen on the exhaust air pipe.
Dryer does not start.
■
Mains plug plugged in or fuse checked?
■
Start button selected?
■
Dryer door open? Close the door.
■
Program selected? Select a program.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Program starts after a delay.
Display panel goes off
and Start button flashes.
Not a fault. Energy saving mode is active
Programme terminates
shortly after starting.
■
Ambient temperature greater than 5 °C?
■
Is the appliance loaded with the laundry?
■
Load too small for selected programme? Use timed programme.
■
Loaded laundry dry?
The door opens by itself. Push the door closed until you hear it engage.
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong program for the type of fabric. All the required information can
be found in the program table.
■
Remove clothes immediately after drying. Creasing may occur if they are
left in the drum.
Water is leaking out.
Not a fault. The dryer may be positioned on an incline. Level the dryer.
* depending on the model
Summary of Contents for WTA792L7SN
Page 1: ...en Installation and operating instructions Tumble dryer WTA792L7SN ...
Page 38: ...6 ...
Page 39: ...6 ...
