Bosch WTA79200GB, Installation And Operating Instructions Manual

Page: 30 / 40

en
Signal setting
30
3.
Remove the fluff from the recess in
the fluff filter.
Note:
Ensure that no fluff falls into
the open shaft.
4.
Open the fluff filter and remove all
the fluff.
5.
Rinse away the fluff under running
water or clean the fluff filter in the
dishwasher.
6.
Dry the fluff filter, close it and reinsert
the fluff filter.
Caution!
The dryer may be damaged.
Do not operate the dryer without a fluff
filter or if the fluff filter is defective.
M
Signal setting
Signal setting
You can change the following settings:
■
The spin speed that is used for
spinning your laundry before it is
dried,
■
The volume of the audible signal at
the end of the program,
■
The volume of the audible button
signals.
You will need to activate the setting
mode in order to change these settings.
Activating setting mode
1.
Switch the dryer on.
2.
Select the "Cottons" programme in
position 1 and wait for five seconds.
The symbols go out in the display panel
and the programme duration is
displayed.
1.
Press and hold the Start button and,
at the same time, turn the
programme selector clockwise to
position 2.
2.
The
spin speed
is shown in the
display.
3.
Press the "Finish in" time button or
the drying time button to change the
spin speed.
4.
Turn the program selector clockwise
to position 3.