6 720 607 800 (2016/02)
10 | Use
3.3
Regulation of water temperature
To regulate the emitted water temperature:
▶ turn the selector , to the desired value.
Fig. 5
▶ When the desired value has been selected, open the hot
water tap.
3.4
Breakdown indication
The appliance incorporates a breakdown indication system.
Anomalies are detected by the red light on the reset button
(
Fig. 3, [1]). The appliance can only be restarted once the
fault has been repaired and the reset button pressed.
To identify the fault consult chapter 10 in this manual.
3.5
Purge appliance
If there is a risk of freezing, proceed as follows:
▶ Loosen the purge screw (Fig. 6) located on the water inlet
pipe.
▶ Empty the appliance of all water.
Fig. 6
Purge screw
The temperature value on the regulator
corresponds to the emission temperature.
If the temperature selected is superior to that
permitted by the power of the appliance, the
water may not achieve the desired
temperature. In this case, the exit flow should
be adjusted:
▶ Close the hot water tap until the desired
value is acquired.
CAUTION:
▶ The area in front of the burner can reach
very high temperatures, and there is a
risk of burning on contact.
