en
Basic operation
32
14.8 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
1.
Press
Inicio/Pausa+Carga
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows: End(Fin).
2.
If is selected, the laundry is not
spun and the water is drained after
rinsing.
Notes
¡
If the laundry is not removed, the
Anti-Crease programme starts after
15 minutes. The programme takes
around 30 minutes. The display
shows 0
：
00,
，
and
End(Fin) alternately and ap-
pears.
Press any button to stop the Anti-
Crease programme and to remove
the laundry.
¡
If appears, the appliance cools the
laundry.
When goes out, the laundry has
cooled down.
14.9 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
Inicio/
Pausa+Carga
.
3.
To resume the programme, after
the desired soaking time, press
Inicio/Pausa+Carga
.
14.10 Adding laundry
1.
Press
Inicio/Pausa+Carga
.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note:
If appears, it is not pos-
sible to add laundry.
When goes out, it is possible to
add laundry.
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Inicio/Pausa+Carga
.
14.11 Cancelling the pro-
gramme
1.
Press
Inicio/Pausa+Carga
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
programme.
– If the water level is high, start
the programme or select a
suitable programme for draining.
→
3.
14.12 Cancelling the drying
programme
14.13 Unloading the laundry
1.
Open the appliance door.
2.
Remove the laundry.
