Bosch WKD28541GB, Instruction Manual And Installation Instruction

Page: 15 / 36

15
Washing and drying options
Temperature °C button
The temperature can be adjusted individually for each programme.
To adjust it, press the
°C
(Temperature) button repeatedly until the
required temperature is displayed.
Spin speed button
B
The spin speed can be individually adjusted for each programme.
To set the spin speed, press the
B
(Spin) button repeatedly until the
required spin speed is displayed.
$
(Rinse hold) deactivates the spin function. The laundry remains in the
rinsing water.
The automatic unbalanced load detection system ensures that the laundry
is evenly distributed using several initial spins. If the laundry is extremely
unevenly distributed, the speed of the final spin is reduced or the spin
cycle is not performed for safety reasons.
option button
set button
The set programmes can be individually adjusted.
To choose the required option:

Press the
option
button repeatedly until the required option is selected
(indicator lamp flashes).

Press the
set
button to switch the option on/off (indicator lamp lights
up/does not light up).
If you press and hold the
option
~
button, all the options scroll through.
Options (symbols on the display panel)
T
Pre-wash
Prewash at 35 °C. Suitable for heavily soiled laundry.
X Intensive
Prolonged washing time. Suitable for particularly heavily soiled laundry
with dried-on stains. Cannot be combined with
R
Flexi Time
Q Easy-iron
Special spin sequence with subsequent fluffing. Gentle final spin at
reduced speed. Slightly increased residual moisture in the laundry.
Reduces creasing and laundry is easier to iron.
Z
Water Plus
Increased water level and additional rinse cycle. For regions with very soft
water or for further improving the rinsing result. Any detergent residues
are removed.
R
Flexi Time
Sets the washing time. normal-medium-short .
C
Signal
Activates or deactivates the audible signal.
0
Finished in button
You can postpone Programme start before it begins. Using the Remaining
time, you can determine when the selected programme is to end. The
remaining time can be set in one-hour increments, up to a maximum of
24 hours. Press the
0
(Finished in) button repeatedly until the required
number of hours is displayed.
Then press the
A
(
Start/
Pause) button, the programme will start after a
delay according to the set (Remaining time). The required time to the end
of the programme is shown on the display panel.
Rinse hold
Unbalanced load detection
system
i