Bosch WKD24361EE, Instruction Manual And Installation Instruction

Page: 14 / 36

14
Special programmes
limp. pelusas / fios (Fluff Clean)
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol
l
(
Fluff removal
cycle
) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The
l
(
Fluff Clean
)
symbol goes out after the programme starts.
To run the
limp. pelusas / fios (Fluff Clean)
programme, proceed as
follows:

Make sure that the drum is completely empty and close the door.

Set the programme selector to
limp. pelusas / fios (Fluff Clean)
.

Press the
A
(
Inicio
/Pausa) button.
You can also run the
limp. pelusas / fios (Fluff Clean)
programme at any
time without prompting from the appliance.
'
+
0
(Rinse + Spin)
:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to
$
(Rinse stop) before starting the
programme → page 15.
+
+
0
(Empty + Spin)
:
Drain the rinsing water following a programme with
$
(Rinse stop)
→ page 15.

Turn the programme selector to
+
+
0
(Empty + Spin)
.

Set the spin speed to
$
(Rinse stop).

Press the
A
(
Inicio
/Pausa) button.
or
Drain
and
spin at the desired spin speed:

Turn the programme selector to
+
+
0
(Empty + Spin).

Press the
0
(Spin)
button repeatedly until the desired spin speed is
set.

Press the
A
(
Inicio
/Pausa) button.