en
Troubleshooting
44
Fault
Cause and troubleshooting
"E:30 / -10" and/or
1.
First wait approx. 5 minutes until the drain process
ends.
2.
To reset the error message, switch the appliance
off.
3.
Switch the appliance back on.
4.
If the error message is displayed again, call cus-
tomer service.
→
The detergent drawer has not been pushed in fully.
▶
Push in the detergent drawer until the symbol goes
out.
The pump unit is not inserted.
1.
Insert the pump unit into the detergent drawer.
→
"Cleaning the detergent drawer", Page 37
2.
Push in the detergent drawer until the symbol goes
out.
lights up.
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
"Cancelling the programme", Page 32
Water level is too high.
▶
Select a suitable programme for draining.
→
flashes.
Door is not closed.
1.
Close the door.
2.
Press
to start the programme.
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press
to start the programme.
All other error codes.
Malfunction
▶
Call the after-sales service.
→
"E:30/-20"
Solenoid valve defective.
▶
Call the after-sales service.
→
Detergent dosage is too high.
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
Additional water is added.