NLSet up and connect
If the device is tilted more than 40°,
residual water can run out of the
device and cause material damage.
▶
Carefully tilt the device.
▶
Transport the device upright.
4.4 Removing transport locks
The device is secured for transport
with transport locks at the rear of the
device.
installation site
Plinth
Requirements
Remark:Keep the screws of the
transport locks and the sleeves for
later transport
The device with
confirm.
1.
Pull the hoses out of the holders.
Floor with wooden
beams
Place the device
guess at a
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
kitchen
The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
2.
Loosen and remove all bolts of the 4
transport locks with a SW13 open-
end wrench
†
on a wall
no snakes
between wall and
clamping device
man.
14
