operation
en
31
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.8 Starting the programme
Requirement:
A programme has
been set.
→
"Setting a programme", Page 29
▶
Press
Inicio/Pausa+Carga
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.The display shows either the
programme duration or the "Ready
in" time.
a
After the programme has ended,
the display shows: End.
13.9 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:
A programme has
started.
→
1.
Press
Inicio/Pausa+Carga
.
The appliance pauses.
Note:
If you want to add laundry,
follow the instructions on the dis-
play.
→
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Inicio/Pausa+Carga
.
13.10 Cancelling the pro-
gramme
1.
Press
Inicio/Pausa+Carga
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
programme.
– If the water level is high, start
the programme or select a
suitable programme for draining.
→
3.
13.11 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡
Rinse Stop is activated.
¡
The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1.
Set the programme or a pro-
gramme for draining the water.
→
2.
Press
Inicio/Pausa+Carga
.
13.12 Unloading the laundry
1.
Open the appliance door.
2.
Remove the laundry.
13.13 Switching off the appli-
ance
1.
Turn the programme selector to .
2.
Turn off the tap.