2 609 005 792 | (25.10.11)
Bosch Power Tools
30
| English
During the charging procedure, the handle of the machine warms up. This
is normal.
Disconnect the battery charger from the mains supply when not using it
for longer periods.
The power tool cannot be used during the charge procedure; it is not de-
fective when inoperative during the charging procedure.
f
Protect the battery charger against moisture!
Observe the notes for disposal.
Changing the Tool (see figure B)
f
Do not use double-sided screwdriver blades that are longer than
25 mm.
Insert the screwdriver bit
1
directly into the tool holder
2
.
Eccentric Driver Head/Angle Driver Head/Torque Attach-
ment (see figures C
–
F)
The eccentric driver head
13
enables screwdriving close to edges.
The angle driver head
14
enables screwdriving at hard to reach locations.
With the torque presetting ring
16
on the torque attachment
15
, the re-
quested torque can be preset in 10 steps. With the correct setting, the
tool bit is stopped as soon as the screw is driven flush into the material or
when the set torque is reached.
Assembly (see figures C–D)
For assembly of the attachments, pull the rubber cap
3
off toward the
front. Afterwards the attachments can be mounted. The attachments can
be mounted offset by 45°.
Dismounting (see figures E–F)
To dismount the attachments, turn the release ring
18
in rotation direc-
tion
n
and pull the attachment off toward the front. Afterwards, mount
the rubber cap
3
again.
OBJ_BUCH-826-006.book Page 30 Tuesday, October 25, 2011 2:37 PM
