Additional programme settings
en
39
p
(Easy iron)
A special operation using reduced spin
speed followed by fluffing to help
reduce creasing.
Touch
p
(Easy iron)
to activate or
deactivate it.
Note:
If
p
(Easy iron)
has been
activated, the laundry will have retained
a higher than average level of moisture
after spinning.
Z
(Water plus)
Increased water level for gentler
treatment of the laundry.
Touch
Z
(Water plus)
to activate or
deactivate it.
â
(Memory)
With memory you can save a selected
programme with your favourite settings.
To store
:
1.
Switch on the appliance.
2.
Select a programme.
3.
If required, change the programme
default settings and/or select
programme additional settings.
4.
Touch and hold
â
(Memory)
button
for approx. three seconds.
The programme is saved if all of the
settings flash briefly.
Calling up
: touch
â
(Memory)
button
briefly after you switch on the appliance.
Reset
: touch and hold
â
(Memory)
button again for approx. three seconds
after selecting the new programme and
settings.
Á
(Silent)
Function designed for noise reduction.
Washing and drying process noise will
be reduced, and ending signal will be
switched off.
Note:
If silent is selected for wash only,
remaining moisture of the laundry will
be slightly increased. The spin result
may not be satisfying. Before hanging
you can select
Στύψιμο
(Spin)
programme to further reduce moisture.
}
(Remote start)
Touching
}
(Remote start) allows you
to start the programme remotely via the
Home Connect app or to call up the
Home Connect settings.
Enabling the programme to be started
remotely via the Home Connect app:
Note:
Remote start can only be
activated if the appliance door is closed
and the appliance is connected to your
home network.
■
Briefly touch
}
(Remote start).
Note:
Remote start will be
deactivated for safety reasons in the
following circumstances:
You open the door.
There is a power failure.
Once the programme has ended.
If you touch
A
on the appliance.
If you briefly touch
}
(Remote
start) again.
If you press
#
to switch off the
appliance.
Calling up Home Connect settings:
■
Touch and hold
}
(Remote start) for
at least 3 seconds.