48
Odour formation in
the washing
machine.
Run
Βαμβακερά
(Cottons) 90 °C
programme without washing.
Use standard detergent.
Repeated, intensive
foaming.
– Check basic dosage settings and dosage strength.
– If required, use a different liquid detergent.
Detergent/softener
drips off the seal and
collects on the door
or in the seal fold.
Too much detergent/softener in the dispensers. Observe
max
mark in the dispensers.
i-DOS
i
/
w
presetting deleted.
If the
i-DOS
i
/
w
: content
menu setting is changed, all settings are
changed.
Loud noise
formation, vibrations
and “wandering”
during spin cycle.
– Appliance aligned?
Align the appliance.
– Appliance feet fixed?
– Transportation safety devices removed?
Remove transportation protection devices.
Display panel/
indicator lights do
not function while
the appliance is
running.
– Power failure?
– Fuse tripped? Switch on/replace fuse.
– If the fault occurs repeatedly, call customer service.
The programme
takes longer than
usual.
– Not a fault – unbalanced load detection system adjusts
imbalance by repeatedly distributing the washing.
– Not a fault – foam detection system active – several rinse cycles
are switched on.
Detergent residue
on the washing.
– Occasionally phosphate-free detergents contain water-insoluble
residue.
– Select
Rinsing
or brush the laundry after washing.
In the pause status
A
Έναρξη
/
Παύση
(
Start/Pause
)
flashes very quickly
and a signal sounds.
– Water level too high. Washing cannot be reloaded. Immediately
close washing machine door.
– Select
A
Έναρξη
/
Παύση
(
Start
/Pause) to continue the
programme.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the tap and call customer service.
Faults
Cause/Remedy
