Programme default settings
en
37
0
Programme default
settings
Programme default settings
The programme default settings are
displayed in the main menu after
selecting the programme.
Display panel
You can change the default settings as
long as the arrow is displayed in the
main menu.
An overview of all programme settings,
which can be selected depending on
the programme, can be found from
Temperature
s
Depending on what stage the
programme is in, you can change the
set temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.
Spin speed
0
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
The maximum speed that can be set
depends on the model and programme
that has been selected.
Setting 0
: No spin cycles, the water is
only drained. The laundry stays wet
inside the drum, e.g. for items that
should not be spun.
Finished in
ñ
The programme duration is shown after
selecting the programme.
Before starting the programme
, you
can preselect the programme end in
hourly increments (h = hour) up to a
maximum of 24 hours.
After starting the programme
, the
selected number of hours
e.g. 8 h
is
shown on the display panel and counts
down until the wash programme starts.
The duration of the programme is then
displayed.
Note:
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, options, foam
detection function, unbalanced load
detection, the load or soiling may also
change the programme duration.
After starting the programme
, you can
change the preselected number of
hours as follows:
1.
Press the
A
button.
2.
Use the
Finished in
ñ
button to
change the number of hours.
3.
Press the
A
button.
After starting the programme
, while the
programme is running, you can add or
remove laundry if necessary.
