Intelligent dosing system
en
39
¡
If you change the liquid detergent or
fabric softener, empty and clean the
dispenser beforehand.
→
"Cleaning the detergent drawer",
¡
If you wish to use both dispensers
for liquid detergent, adjust the
→
Requirement:
(Detergent)
/
(Softener)
flashes.
1.
Pull out the detergent drawer.
2.
Open the dispenser lids.
3.
Pour liquid detergent
(Detergent)
and fabric softener
(Softener)
into the relevant dispensers.
→
4.
Close the dispenser lids.
Note:
To prevent the detergent dry-
ing out or drying up, do not leave
the dispenser lids open for a long
period of time.
5.
Push in the detergent drawer.
6.
Adjust the basic dosage
→
.
Dispenser contents
When it leaves the factory, the dis-
penser is set for fabric softener
(Softener)
. Alternatively, you can also
use this dispenser for a second liquid
detergent
(Detergent)
.
Notes
¡
If you change the content of the dis-
penser, the basic dosage for this
dispenser is reset.
¡
If you use both dispensers for liquid
detergent, you must select a dis-
penser which is to be used during
washing.
Adjusting the dispenser contents
1.
Press and hold
i-DOS
for ap-
prox. 3 seconds.
2.
To set
(Detergent)
, press
i-
DOS
.
a
The display shows
(Detergent)
.
3.
To set
(Softener)
, press
i-
DOS
again.
4.
To end the setting process, wait
briefly.
Basic dosage
You can adjust the preset basic
dosages for liquid detergent and fabric
softener.
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the de-
gree of soiling of the laundry.
Always set a basic dosage that corres-
ponds to the dosage for a standard
load of 4.5 kg.
→
Adjusting the basic dosage
You can individually adjust the basic
dosages for each dispenser.
Summary of Contents for WAX32KH0BY
Page 54: ...en Cleaning and servicing 54 3 Connect the water inlet hose and check for leaks ...
Page 70: ......
Page 71: ......