Troubleshooting
en
61
Errors
Cause
Troubleshooting
The water is not draining.
Drain pump is blocked.
▶
Rinse Hold
is activated.
▶
Continue the programme by selecting
Spin
or
Drain
and pressing
Start/
Reload
.
the programme status is Rinse Hold",
Page 43
The water outlet hose is con-
nected too high.
▶
Install the water outlet hose at a max-
imum height of 1 metre.
Water is not flowing in. Deter-
gent is not being dispensed.
You have not pressed
Start/
Reload
.
▶
Press
Start/
Reload
.
The filter in the water inflow is
blocked.
▶
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked
or jammed.
▶
Ensure that the water inlet hose is not
kinked or jammed.
The spin cycle runs several
times.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
The programme duration
changes during the wash
cycle.
The programme operation is
optimised electronically. This
may change the programme
duration.
▶
Not a fault – no action required.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
▶
Not a fault – no action required.
No water is visible in the
drum.
Water is below the visible
area.
▶
Not a fault – no action required.
