en
Troubleshooting
66
Problem with results
Fault
Cause
troubleshooting
Creasing.
The spin speed is too high.
▶
The next time you run a wash cycle,
set a lower spin speed.
The load is too large.
▶
The next time you run a wash cycle,
reduce the amount of laundry being
loaded.
The wrong programme is se-
lected for the type of fabric.
▶
Select the programmes that are
suitable for the type of fabric.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
A low spin speed is selected.
▶
The next time you run a wash cycle,
set a higher spin speed.
▶
Start the
Spin
programme.
Less Ironing
is activated.
▶
Select the programmes that are
suitable for the type of fabric.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the
drum.
Note:
Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
▶
Start the
Spin
programme.
Detergent residue on the
damp washing.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
▶
Start the
Rinse/Freshen Up
pro-
gramme.
Unsuitable detergent added
to the dispenser of the intelli-
gent dosing system.
1.
Check whether the detergent used
is suitable.
"Detergents and care products",
2.
Drain the dispenser.
"Cleaning the detergent drawer",
3.
Clean the dispenser.
4.
Refill the dispenser.
"Filling the dispenser", Page 46
Basic dosage is not correctly
adjusted.
▶
If intelligent dosing is activated, re-
duce the "basic dosage"
