Bosch WAX28M60GR, User Manual

Page: 53 / 68

Troubleshooting
en
53
Fault Cause and troubleshooting
"E:30 / -80"
▶
Remove any unapproved extensions from the water
hose. Connecting the appliance
"E:36 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drain pump", Page 46
"E:38 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drum", Page 44
if the fault is displayed again,
▶
→ "Cleaning the drain pump", Page 46
Inlet opening of the rubber gasket is blocked.
▶
→ "Cleaning the intake opening in the rubber gas-
ket", Page 48
⁠ The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow → Page 49 .
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
⁠ Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
⁠ lights up. The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 40
Water level is too high.
▶
Start the
Άντληση
programme.
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press
Έναρξη/Προσθήκη ρούχων
to start the
programme.