Cleaning and maintenance
en
57
– Protect the rear drawer connector
against water, detergent or fabric-
softener residue; if necessary,
clean the outer surfaces with a
soft, damp cloth. Dry before
putting back in.
e) Clean the drawer and the cover
with a soft, damp cloth or a hand
shower. Also clean the inner
surfaces with a soft, damp cloth.
f) Dry the drawer and the cover and
put them back together.
g) Push the drawer handle back in
from above until you feel it click
in place.
h) Clean the inside of the detergent-
drawer housing.
i) Push the detergent drawer in
completely.
The drain pump is blocked,
emergency draining
:
Warning
Risk of scalding!
When you wash at high temperatures,
the water gets very hot. If you come into
contact with the hot water, you may be
scalded.
Allow the water to cool down.
1.
Turn off the water tap so that no
more water can flow in and has to be
drained via the drain pump.
2.
Switch off the appliance. Pull out the
mains plug.
3.
Open and remove the service flap.
4.
Take the drain hose out of the
retainer.
Remove the sealing cap and pour
the water out into a suitable
container.
Replace the sealing cap and place
the drain hose back in the retainer.
5.
Carefully unscrew the pump cover;
residual water may leak out.
Clean the interior, pump-cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
