Bosch WAV28MHASN, User Manual And Installation Instructions

Page: 31 / 60

operation
en
31
13.8 Starting the programme
Requirement:
A programme is set.
→ "Setting a programme", Page 29
▶
Press .
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows:
-0-
.
13.9 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
.
3.
To resume the programme, after
the desired soaking time, press
.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:
A programme has
started.
→
"Starting the programme",
Page 31
1.
Press .
The appliance pauses.
Note:
If you want to add laundry,
follow the instructions on the dis-
play.
→
"Display", Page 21
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press .
13.11 Cancelling the pro-
gramme
1.
Press .
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.
– If the water level is high, start
the
Spin
programme or select a
suitable programme for draining.
→
"Programmes", Page 24
3.
Remove the laundry.
→
"Unloading the laundry",
Page 31
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡
Rinse Stop is activated.
→
"Buttons", Page 22
¡
The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1.
Set the
Spin
programme or a pro-
gramme for draining the water.
→
"Programmes", Page 24
2.
Press .
13.13 Unloading the laundry
1.
Open the door.
2.
Remove the laundry from the
drum.
13.14 Switching off the appli-
ance
1.
Press ⁠ .