NLSet up and connect
4.5 Connecting the device
Remark:Observe the pumping
heights.
The maximum pumping height bed
Connect water supply hose
1.
Connect the water supply hose to the
appliance.
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
washbasin
the water
feeding hose with
a bend
fixate and
gene.
2.
Connect the water inlet hose to the
tap (26.4 mm = 3/4").
plastic stand
pipe with rubber
run muff or a
floor drain
the water
feeding hose with
a bend
fixate and
gene.
3.
Open the tap carefully and check
that the connections are tight.
Connection types for water drainage
The information will help you to connect
this appliance to the water outlet.
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can come loose from
the installed connection position.
know.
g against un-
gene.
▶
The water drain hose
intended to loosen bor
16