first time
en
19
tivate the activated settings by re-
peatedly pressing on the relevant
buttons on the display.
ATTENTION!
Pressing on the display with force
may cause damage.
▶
Do not apply heavy pressure on
the display.
▶
Do not press on the display using
pointed or sharp objects.
1
2
first time
6 Before using for the
first time
first time
Prepare the appliance for use.
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
1.
Press .
The switch-on process takes a few
seconds.
2.
Set the
Limp. tambor
pro-
gramme.
3.
Close the door.
4.
Pull out the detergent drawer.
5.
Pour approx. 1 litre of water into
the manual dosing compartment.
6.
Add washing powder to the
manual dosing compartment.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
7.
Push in the detergent drawer.
8.
Press
to start the programme.
a
The display shows the remaining
programme duration.
a
After the programme has ended,
the display shows:
End
.
9.
Start the first wash cycle or press
to switch off the appliance.
