Cleaning and servicing
en
41
Clean the water inlet filters.
Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
1.
Turn off the tap.
2.
Set a programme, except for
Rinse
,
Spin
or
Drain
.
3.
Start the programme and leave it
to run for approx. 40 seconds.
4.
Switch off the appliance.
5.
Disconnect the appliance's mains
plug from the power supply.
Cleaning the filter on the tap
Note:
Please read the information in
the Safety →
sections
to ensure that you use the appliance
safely.
Requirement:
The water inlet hose is
empty.
1.
Remove the water inlet hose from
the tap.
2.
Clean the filter with a small brush.
3.
Connect the water inlet hose and
check for leaks.
Cleaning the filter on the
appliance
Note:
Please read the information in
the Safety →
sections
to ensure that you use the appliance
safely.
Requirement:
The water inlet hose is
empty.
→
"Emptying the water inlet hose",
1.
Disconnect the hose from the rear
of the appliance.
Summary of Contents for WAJ280L7SN
Page 55: ......