Videojet connect 7000
Product Overview | en
11
Bosch Security Systems
Installation Manual
2019-08 | 1.7 | F.01U.291.524
3
Product Overview
The device VIDEOJET connect 7000 (VJC-7000-90) is a full-featured network power supply
unit that can operate a variety of Bosch PTZ cameras such as MIC7000. The device includes
one (1) HPoE network connection, two (2) standard network interfaces for connections to
additional IP devices, one (1) slot for an optional CompactFlash (CF) memory card, two (2)
slots for use with SFP-based fiber optic modules, alarm/washer control interfaces*, and audio
in.
Specification
Value
Power requirements
100 VAC - 240 VAC (90 VAC - 264 VAC with tolerance
considered), 50/60 Hz; 56V output
Alarm inputs *
Four (4) normal dry contacts (selectable N.O./N.C.)
Monitored supervised alarm input (Alarm 1), 2.2K ohm
(Ω) end-of-line terminating resistor
Alarm outputs *
Three (3) open collector outputs, 32 VDC, 150 mA
Audio *
One (1) mono line in; one (1) mono line out
connector 3.5 mm stereo jack
signal line in 9 kohm typical, 5.5 Vpp max. 25
signal line out 3.0 Vpp at 10 kohm typical;
2.3 Vpp at 32 ohm typical;
1.7 Vpp at 16 ohm typical
Washer driver output *
Dry contact relay, 250 V, 5 A
Washer switch *
Push button to activate/test the washer relay
momentarily
Communication
Three (3) 10BASE-T/100BASE-TX/1000Base-TX.
If SFP fiber optic modules installed: two (2) 1000 BASE-
FX
Local storage
One (1) slot for an optional CompactFlash (CF) memory
card, Type I / Type II, True IDE Mode, 1 TB max (user-
supplied)
SFP (small form-factor pluggable) Two (2) slots for use with SFP-based fiber optic modules
(1 GB only) as recommended in the section
The device provides the following features:
–
HD-Base T PoH dedicated for one RJ45 Ethernet connection between the device and a
Bosch IP camera powered by PoE/High PoE
–
a push button on the PBCA to allow users to activate/test a connected washer pump
accessory * (optional, user-supplied)
–
ability to control connected cameras using the built-in web browser of the device
–
support for daisy chaining a maximum of 50 units (based on specific conditions)
* Note
: This feature is valid only for a MIC7000 camera "bound" to Camera 1.
Summary of Contents for VJC-7000-90
Page 1: ...Videojet connect 7000 VJC 7000 90 en Installation Manual ...
Page 2: ......
Page 57: ......
